Extron electronic Network Router Demonstration Kit User Manual

Setup Guide for AVTrac^™Demonstration Kit

The AVTrac Demonstration Kit shows how the AVTrac system meets customers' application needs. The kit components

can be unpacked from the carrying box as shown in the ﬁgures below. To repack the kit, reverse the steps.

The illustrations below show the US version of the AVTrac Demonstration kit. The International and Universal

models are similar in size and packaging, but contain a single AC outlet, which may be connected to double insulated

power cable, or ﬂex conduit without wires.

If the box is to be reused, remember to save

the packing foam.

Pre-cut

Carpet Pieces (2)

This kit is for demonstration

purposes only. The AC power module is not

wired to distribute power and must not be

connected to an electrical power source.

Remove carpet pieces.

Remove top foam and foam

covering side ramps.

Connectivity Box (1)

End Ramps (2)

Remove side and end ramps.

AC Conduit (1)

Side Ramps (2)

Remove track pieces and

connectivity box with AC

conduit.

Carpet Finish

Cover Track (1)

Rubber finish

Cover Track (1)

Base Track (1)

68-1530-01

Rev. B 02 09