OEM Systems Speaker AP 615 LCRS User Manual

15° Angled LCRS In-Ceiling  
1. Check ceiling area for concealed obstructions such as wiring, plumbing, heating ducts, etc.  
2. Use a “stud finder” to locate positions of joists or rafters. Make sure that your intended locations for  
your speakers are unobstructed and that the holes will be at least 2 inches away from joists or rafters.  
3. Use the supplied compass or cut-out template/paint mask to draw a circle with the diameter that  
corresponds to the model of your speaker on the chart below, and carefully cut out the hole.  
4. Remove grille from speaker assembly using included grille remover.  
5. Before installation, turn the “Angle Lug Installation Clamps” (Item A) so they are positioned as in  
photo below. This way, they will clear the cut-out hole for installation.  
6. Prior to inserting speaker assembly into cut-out hole, attach speaker wires. Make sure to observe  
polarity (the “+” and the “-”). Speakers wired out of phase will exhibit an apparent loss of bass  
response. The wires will be held in place by the “Spring Clip Terminals” (Item B). Wires should be  
stripped about .25". Tinning of wire ends will assure a trouble free installation, but is not necessary.  
7. Insert speaker assembly into hole and orient it so  
that it is angled toward the listening area. A clear  
plastic template is included to precisely align the  
direction of the speaker. The template must be  
removed before the speaker is operated.  
8. Begin to tighten installation screws. As you start to  
turn each screw, the “Angle Lug Clamps” will rotate  
outward to engage ceiling material (Item C). CAUTION:  
Do not overtighten the clamps. Too much torque may  
snap off the lug, causing the speaker not to seat  
securely. A snug fit is all that is necessary to assure  
proper performance.  
9. If speaker assemblies are to be painted, either  
before or after installation, use the paint masking  
template (cardboard disc) to cover the speaker  
driver(s) to prevent damage. DO NOT TRY TO PAINT THE  
GRILLE AND FRAME ASSEMBLY TOGETHER. The grille  
should always be painted separately. Use thin coats  
taking care not to block perforations with excessive  
paint.  
10. Your speaker includes a pivoting tweeter and it may be aimed to achieve even better imaging.  
Tweeter output should be directed toward the typical listening position. USE CARE TO AVOID  
DAMAGING THE DOME OF THE TWEETER DURING AIMING!!  
Mounting Diameter x Depth  
AP-615 LCRS  
AP-815 LCRS  
9-1/4" round x 5" deep  
11-1/2" round x 5-3/4" deep  
PS-615 LCRS  
PS-815 LCRS  
9-1/4" round x 5" deep  
11-1/2" round x 5-3/4" deep  
Rev. A  
page 1 of 1  
 

Nintendo Video Games 70277A User Manual
Nintendo Video Games Legend of Zelda Ocarna of Time 3D DS User Manual
Norcent Technologies Digital Photo Frame PF 802 User Manual
NuTone Saw CFVS 1N User Manual
Omron Blood Pressure Monitor HEM712C User Manual
Onkyo Stereo Receiver TX NR1030 User Manual
Optoma Technology Projector EP771 User Manual
Oracle Audio Technologies Server A86828 01 User Manual
Panasonic Camera Accessories CF VZS251A User Manual
Panasonic Telephone KX TA616 User Manual